Diagnose and configure modules on your Ford Focus 2 and C-Max I using an ELM327 or ELS27 interface. These tools provide CAN-bus access to various vehicle modules:

Engine Control Module (ECM):

Access module information, read and clear diagnostic trouble codes (DTCs), reboot the module, and reset the long-term fuel trim (KAM) for the following engine types: ESU-411/418 (1.8 125/2.0 145), SIM28/29 (1.4 80/1.6 100/115), and ESU-121/131 (1.8 120/2.0 145).

Instrument Panel Cluster (IPC):

Access module information, read and clear DTCs, configure the module, reboot the module, change the odometer reading, and perform odometer correction (mileage correction).

Brake Control Module (BCM):

Access module information, read and clear DTCs, configure the module, reboot the module, reset the Dynamic Stability System (DDS) calibration, and perform brake bleeding.

Body Control Module (BCM):

Access module information, read and clear DTCs, configure the module, and reboot the module.

Safety Restraint Control Module (SRCM):

Access module information, read and clear DTCs, configure the module, reboot the module, and clear crash data.

Transmission Control Module (TCM):

Access module information, read and clear DTCs, and reset the KAM.

Climate Control Module (CCM):

Access module information, read and clear DTCs.

Audio Control Module (ACM):

Access module information, read and clear DTCs, and retrieve the radio code (for M-series radios).

*Note: Some features require the full version of the software.

To unlock the full potential of the application and access additional modules, a minor modification to your ELM327 adapter may be necessary. Instructions for this modification can be found here: [ttpp] ELS27 adapters can be purchased at: [yyxx]. For ELS27USB, set the baud rate to 38400; for ELS27BT, use the ELS27 Baudrate utility to set it to 2,000,000.